通过热显微镜、微量差示扫描量热法、密度和声速测量以及分子动力学模拟的结合，获得了在不同4'-羟基苯乙酮（HAP）从水中成核之前溶液中发生的结构重排的见解。结果证实了我们之前的观察，即HAP的冷却结晶由液液相分离（LLPS）介导，并且根据最初选择的浓度范围，选择性地导致不同晶型的形成。对LLPS开始前溶液性质的分析表明，在xHAP < 0.004（I区）的HAP摩尔分数范围内，最终结晶为水合物H2的小型溶剂化簇最初存在于溶液中，随着温度的降低，其大小、形状和HAP/H2O比例保持大致不变。对于xHAP > 0.005范围（III区），其中无水I型结晶，大型HAP/水聚集体（当xHAP接近0.005限值时甚至可以渗透整个系统）最初就存在于溶液中。随着冷却的进行，这些聚集体变得更加紧凑，这一过程伴随着水分含量的减少，并且溶液浓度越高，这种减少越显著。0.004 < xHAP < 0.005（II区）范围对应于一个过渡区域，在此区域内，随着xHAP的增加，溶液的物理性质最初从I区的典型特性演变，而在某个点突然改变并开始向III区的典型特性收敛。在所有区域中，LLPS形成的胶体颗粒（结晶由此产生）在冷却过程中也可以减少其含水量，但这个过程的程度随着xHAP从形成水合物的I区和II区移动到形成无水I型的III区而增加。

In this work insights into the structural rearrangements occurring in aqueous solution, prior to the nucleation of different 4'-hydroxyacetophenone (HAP) forms from water were obtained, through a combination of thermomicroscopy, micro-differential scanning calorimetry, density and speed of sound measurements, and molecular dynamics simulations. The results confirmed our previous observation that cooling crystallization of HAP is intermediated by liquid-liquid phase separation (LLPS) and, depending on the initially selected concentration range, selectively leads to the formation of different crystal forms. Analysis of the solution properties before the onset of LLPS revealed that, in the HAP mole fraction range xHAP \< 0.004 (Zone I), where hydrate H2 ultimately crystallizes, small, solvated clusters are initially present in solution, which remain approximately invariant in size, shape and HAP/H2O proportion as the temperature decreases. For the xHAP \&gt; 0.005 range (Zone III), where anhydrous form I crystallizes, large HAP/water aggregates (that can even percolate the whole system as xHAP approaches the 0.005 limit) are already initially present in solution. As cooling progresses, they become more compact, a process accompanied by a reduction in water content, and which is more significant as the solution concentration increases. The 0.004 \< xHAP \< 0.005 (Zone II) range corresponds to a transition region where, as xHAP increases, the physical properties of the solution initially evolve from those typical of Zone I and, at a certain point, abruptly change and start converging to those typical of Zone III. In all zones, the colloidal particles formed upon LLPS (from which crystallization results) can also reduce their water content on cooling, but the extent of this process increases as xHAP moves from Zones I and II, where hydrates are formed, to Zone III, where anhydrous Form I is produced.