我们提出了一种在石墨烯中实现谷极化的全电控方案。该方案包括一个有限尺寸的石墨烯片，两端分别连接到普通金属电极，并且连接处沿着锯齿状边缘对齐，而扶手椅状边缘保持自由。每个普通金属电极有两个端口，当在一个端口施加偏置电压而其他三个端口接地时，由于石墨烯与普通金属之间的横向动量匹配，谷极化得以产生。当普通金属的费米波矢大约为石墨烯中 $K$ 和 $K'$ 谷之间间隔的一半时，谷极化达到最大值。我们分析了系统参数（如石墨烯片的宽度和长度以及石墨烯和普通金属的化学势）对电导率和谷极化效率的影响。随着石墨烯片宽度的增加，其电导率增大；而长度增加初期会降低电导率，随后由于法布里-珀罗干涉效应表现出振荡行为。由于石墨烯区域内的来回反射导致的谷间混合，谷极化效率随石墨烯长度增加而减小。此外，我们研究了石墨烯中的无序效应对谷极化的影响，发现虽然近狄拉克点附近的电导率因态密度增强而随无序强度增加而增大，但谷极化效率因谷间散射而下降。我们的结果为基于石墨烯器件的谷电子学应用提供了重要见解。

We propose an all-electrical setup for achieving valley polarization in graphene. The setup consists of a finite graphene sheet connected to normal metal electrodes on both sides, with the junctions aligned along the zigzag edges while the armchair edges remain free. Each normal metal has two terminals, and when a bias is applied at one terminal while keeping the other three grounded, valley polarization arises due to transverse momentum matching between graphene and the normal metal. The valley polarization is maximized when the Fermi wave vector of the normal metal is approximately half the separation between the $K$ and $K'$ valleys in graphene. We analyze the dependence of conductance and valley polarization on system parameters such as the width and length of the graphene sheet, as well as the chemical potentials of graphene and the normal metal. The conductance through graphene increases with its width, while an increase in length initially reduces the conductance before leading to oscillatory behavior due to Fabry-P\'erot interference. The valley polarization efficiency decreases with increasing graphene length due to inter-valley mixing from back-and-forth reflections within the graphene region. Furthermore, we investigate the impact of disorder in graphene and find that while conductance near the Dirac point increases with disorder strength due to enhanced density of states, valley polarization efficiency decreases due to intervalley scattering. Our results provide insights into controlling valley polarization in graphene-based devices for valleytronic applications.