在滑动摩擦表面的磨损过程中，存在一个磨合期，在达到稳定磨损状态之前，表面形貌随时间变化。在稳定磨损状态下，用于描述表面形貌的统计参数几乎保持不变。一些实验研究表明，以不同表面加工精度开始摩擦测试会导致稳态磨损阶段具有相同的最终表面形貌。本文提出了一种分析模型来描述滑动磨损过程中表面形貌的演化。首先，采用Greenwood和Williamson的方法描述名义上平坦的粗糙表面之间的接触。接触的凸峰可能会发生塑性变形或与对偶表面粘附。通过塑性判据和粘附判据，可以得到表面凸峰标准差演化过程的微分方程。该方程具有解析解，且与文献中的实验结果吻合良好。结果表明，最终的表面形貌是划伤磨损与粘附磨损之间竞争的结果。随后，该模型被用于描述从抛光到咬合的不同磨损过程。

During the wear process of surfaces in sliding friction, there is a running-in period during which the topography of surfaces changes with time before reaching the steady wear regime. In the steady wear regime, the statistical parameters used to describe the topography of the surfaces remain almost constant. Some experimental studies have shown that starting friction tests with different surface finish levels leads to the same final topography of surfaces in the regime of steady wear. This article proposes an analytical model to describe the evolution of the topography of surfaces during sliding wear. First of all, the Greenwood and Williamson approach is used to describe the contact between nominally flat rough surfaces. The asperities in contact may undergo plastic deformation or adhesion with the opposing surface. Using a plasticity criterion and an adhesion criterion, it is possible to obtain a differential equation for the evolution of the standard deviation of the asperities of the surfaces. This equation has an analytical solution that is in good agreement with experimental results from the literature. It is shown that the final surface topography is the result of the competition between abrasive wear and adhesive wear. The model is then used to describe different wear processes from polishing to galling.